Subject	What did the cranks look like when you did that?
Posted by	BlackholeZ on August 25, 2016 at 2:02 PM
	This message has been viewed 177 times.
In Reply To	I've done 3 Z's from the bottom posted by Cjw3 on August 24, 2016 at 05:53 PM
Message	I'm hoping I don't have to polish anything. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Just doing bearings? - BlackholeZ 11:34:03 08/24/16 I did rings and bearings on one engine - -Grimm- 12:03:10 08/24/16 You pull the heads or pistons out the bottom? - BlackholeZ 12:22:25 08/24/16 Pulled the heads to hone (n/m) - -Grimm- 14:43:24 08/24/16 I've done 3 Z's from the bottom - Cjw3 17:53:24 08/24/16 What did the cranks look like when you did that? - BlackholeZ 14:02:47 08/25/16 All looked fine.. - Cjw3 20:28:35 08/25/16 I'd pull the engine and do it while it's on a stand, I can't - Tanley (ATL) 12:01:02 08/25/16 I haven't put a stethescope on it - BlackholeZ 14:12:15 08/25/16 Here's the link: - Tanley (ATL) 22:53:28 08/25/16 thanks! (n/m) - BlackholeZ 00:00:11 08/26/16
Post a Followup	You cannot reply to this message because you are not logged in.