TwinTurbo.NET: Nissan 300ZX forum - Simple, be a welder :-)
People Seeking Info
 
   


     
Subject Simple, be a welder :-)
     
Posted by BlackholeZ on February 01, 2017 at 6:16 PM
  This message has been viewed 256 times.
     
In Reply To There's a few people in my Nissan/Infiniti group that run posted by PiotrC70 on February 01, 2017 at 09:16 AM
     
Message I've been playing with my exhaust over the years. I got a cheap top speed exh because my stock stuff was rotting out. It was fun for a bit but annoying for daily use. I installed a turbo-back exhaust on a Mazdaspeed 3 and he didn't want the stock exhaust. It had 2 hefty 2.5" inline resonators on it so I cut them out and installed them in my X-pipe. They were so big I actually had to convert it into an H-pipe. It's much more tame now, almost too tame. I think I'm going to build mufflerless axle back sections for the days that I feel like being a little louder.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.