TwinTurbo.NET: Nissan 300ZX forum - Dude's actually going about it in a decent way
People Seeking Info
 
   


     
Subject Dude's actually going about it in a decent way
     
Posted by BlackholeZ on December 22, 2016 at 4:27 AM
  This message has been viewed 243 times.
     
In Reply To NZR...but will melt your brain anyway. posted by CameronSF on December 21, 2016 at 05:12 PM
     
Message If you look back through his videos he had a single cylinder running on it first and he's been developing it for a while. He's also very candid about the "engineering oversight" that is burning tons of oil that was meant to lubricate the rotary seals.

I've seen dozens of these "revolutionary" motor designs that are a little too big for their britches and never get anywhere, but this guy knows that this is probably going to just be a learning exercise and is treating it as such.

-Dan
VTC Solenoid Caps and install instructions.


"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse."
"'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr
"full alphabetic boost mode" -
ChristopherTheOne

" Purrs like a sexually satisfied black panther." - BigTDogg
"Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.