Subject	Doesn't work right for the reason you mentioned
Posted by	BlackholeZ on August 16, 2016 at 1:39 PM
	This message has been viewed 250 times.
In Reply To	Z1 NA-TT Radiator lower mount kit- reviews? posted by hunterg on August 16, 2016 at 12:14 PM
Message	the stock TT radiator mounts are lower than the NA ones. The Z1 bracket does not lower the rad, and therefore it sits too high. Currently the only option is to cut and weld the mounts properly. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Z1 NA-TT Radiator lower mount kit- reviews? - hunterg 12:14:51 08/16/16 Link inside - hunterg 12:17:41 08/16/16 Used it on a swap we did, worked fine. (n/m) - Bernie (NoVA) 13:53:42 08/16/16 Doesn't work right for the reason you mentioned - BlackholeZ 13:39:26 08/16/16 are TT mounts different than NA? I cut off the NA mounts - hunterg 13:48:00 08/16/16 The mounting interface is the same - BlackholeZ 14:59:59 08/16/16 Re: Z1 NA-TT Radiator lower mount kit- reviews? - NNayak 15:12:11 08/16/16 It works fine for a NA to TT conversion. (n/m) - CmyZ 08:57:04 08/17/16
Post a Followup	You cannot reply to this message because you are not logged in.