Subject	I'd press out the bearing
Posted by	BlackholeZ on April 07, 2016 at 9:43 PM
	This message has been viewed 299 times.
In Reply To	Longshot... Has anyone powder coated their Powertrix posted by PiotrC70 on April 07, 2016 at 07:48 PM
Message	It's probably greased, and could cause some problems during the bake. Just be sure to tell then the bore is a press fit, so they mask it off. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Longshot... Has anyone powder coated their Powertrix - PiotrC70 19:48:36 04/07/16 I'd press out the bearing - BlackholeZ 21:43:46 04/07/16 I had mine redone/re-anodized in blue (n/m) - Woody75 (Denver) 10:12:34 04/11/16 Did you end up pressing out the bearing? (n/m) - PiotrC70 09:48:10 04/12/16
Post a Followup	You cannot reply to this message because you are not logged in.