Subject	Tips on seal removal?
Posted by	300zx90 (CO) on July 31, 2006 at 3:07 PM
	This message has been viewed 793 times.
In Reply To	Attn: 60mm Throttlebody Conversion Users. Important Info >>> posted by Ash's Z on July 31, 2006 at 02:23 PM
Message	I tried to disassemble one of my TB's and couldn't get either of the seal assemblies out of the housing. I removed the mechanical stakes, but neither side would budge. Finally gave up on it. Any tips for removing those bastards? ________________________________________ NA to TT, starting from the ground up... Proper check valve inspection per the FSM...
Follow Ups	Attn: 60mm Throttlebody Conversion Users. Important Info >>> - Ash's Z 14:23:00 07/31/06 good catch...also lucky the seals happen to swap so easily (n/m) - Atl300zxTT (Less Lazy) 14:34:14 07/31/06 Wow there is always more to the story than you first think. (n/m) - pieboy100 14:37:09 07/31/06 Thanks. (n/m) - YugoBernie (NoVA) 14:38:10 07/31/06 nice (n/m) - aliaZ 14:40:34 07/31/06 Well done. (n/m) - Kenny 14:46:32 07/31/06 are the seals the same in both NA and TT tb's? (n/m) - BabyBluey 14:51:42 07/31/06 Yes. (n/m) - Ash's Z 14:53:49 07/31/06 you're alright (n/m) - robo (sebring1970) 15:06:44 07/31/06 Tips on seal removal? - 300zx90 (CO) 15:07:39 07/31/06 How about tossing them in the freezer for about 30 minutes? (n/m) - Dave N 15:17:24 07/31/06 You can't smell frozen fish dude =(. - Kenny 15:24:25 07/31/06 LOL. Yes, my reply was actually serious. I couldn't come - Dave N 15:28:04 07/31/06 I tried heating it assuming the aluminum housing - 300zx90 (CO) 15:50:55 07/31/06 When I swapped in my powder coated ones - MidLifeZ 17:41:16 07/31/06 You used the punch where? - 300zx90 (CO) 19:05:11 07/31/06 Nice find and thanks (n/m) - CollegeBoy (Kauai) 15:15:00 07/31/06 nice find - ARA300ZX 15:30:11 07/31/06 VTF! (n/m) - doug8867 16:39:23 07/31/06
Post a Followup	You cannot reply to this message because you are not logged in.