Subject	Yes, one thing that refutes the theory is that the
Posted by	John B. on May 18, 2006 at 12:57 PM
	This message has been viewed 396 times.
In Reply To	Interesting theory. Not sure how much current posted by Jmartz on May 18, 2006 at 11:23 AM
Message	coil is supposed to be sealed off from the fuel. Other theories involve the electrolysis, but blame a manufacturer defect for the coil not being sealed. There is much speculation, but if the coil is hot at all times, and the fuel does come in contact, the ethanol can easily act as a very low current ground, causing the coil to break down. All theory and speculation though, and i doubt anyone has the money/patience to really investigate it...i will most likely do the 12v switch if i ever get bigger injectors, but probably not for my 370's. (I just need an damn justification to buy bigger injectors).
Follow Ups	1995's "switched-power" injectors (how it was done) - 300zx90 (CO) 18:52:43 05/17/06 excellent research man! VTF! (n/m) - Slobo7x 19:00:52 05/17/06 Addendum - 300zx90 (CO) 19:05:26 05/17/06 I mean really - we all know that '95s are the best :-) (n/m) - YugoBernie (NoVA) 19:23:16 05/17/06 I'll check it out this weekend on my 90 and post a - DAYTONAZ 20:10:27 05/17/06 Dont think its that simple. See the link in my post. - John B. 20:30:32 05/17/06 you also need to account for what else is on the circuit and - Guapo 20:58:13 05/17/06 Im pretty sure i did,did you read the link in my other post? - John B. 21:26:08 05/17/06 I was reffering to DAYTONAZ's idea (n/m) - Guapo 23:23:45 05/17/06 Pfff....learn how to post, rookie. =) (n/m) - John B. 08:35:06 05/18/06 its clear I was following up your post in regard to his :) (n/m) - Guapo 09:14:35 05/18/06 A darn fine idea to check into further. I would.. - Audioquest 00:49:46 05/18/06 Not quite, power is fed TO the ECU and injectors from either - 300zx90 (CO) 09:22:43 05/18/06 Gotcha, after looking breifly at the online diagram that - DAYTONAZ 17:39:47 05/18/06 No relay needed, just splice them into the lead on pin 45 (n/m) - 300zx90 (CO) 17:59:33 05/18/06 Has that particular wire got a color code on it to make - Audioquest 20:12:53 05/18/06 Here is a "half" of a write up. - John B. 20:19:36 05/17/06 Nice work, it's a shame the factory splice isn't in a - 300zx90 (CO) 09:33:27 05/18/06 Thanks bud, you too! (n/m) - John B. 09:48:37 05/18/06 Nice comparison - for folks with the earlier harness, an - jzack 23:41:37 05/17/06 nice vtf (n/m) - Eishozzzz 06:23:06 05/18/06 The un-switched power source to the injectors - Jmartz 08:18:31 05/18/06 Theory: - John B. 08:31:58 05/18/06 Interesting theory. Not sure how much current - Jmartz 11:23:36 05/18/06 Yes, one thing that refutes the theory is that the - John B. 12:57:57 05/18/06 nice (n/m) - aliaZ 12:51:11 05/18/06 With + 12 VDC always applied to the injector, there may be - Zirvana 14:13:47 05/18/06 Now if we can just figure out if the relays will be happy... - David Mcanulty 18:25:18 05/18/06 Read my posts. - John B. 19:58:05 05/18/06 ** Rehosted images ** - 300zx90 (CO) 08:58:46 11/13/07
Post a Followup	You cannot reply to this message because you are not logged in.