Subject	If that's all it is I don't care : ) I've read, however,
Posted by	thumper300zx on December 16, 2005 at 9:54 AM
	This message has been viewed 160 times.
In Reply To	I would guess you are right. Softer rubber has ... posted by Audioquest on December 16, 2005 at 08:01 AM
Message	that the whine is based on how tight the front nut is put on. Here is the comment I received earlier...I just don't see how I could have put it on too tight as it was either right on or just shy of my alignment mark. Musky wrote: "Be carefull not to overtorque the pinion nut when reinstalling, as it WILL whine if too tight. I learned that from experience." I guess I'll need to pull the driveshaft again and loosen 'er up. Z's Rule!
Follow Ups	Differential question, now that it's back on the car... - thumper300zx 06:36:56 12/16/05 Nooooo.... it's back... LOL Don't know the answer, but I've - doug8867 07:05:15 12/16/05 I would guess you are right. Softer rubber has ... - Audioquest 08:01:11 12/16/05 If that's all it is I don't care : ) I've read, however, - thumper300zx 09:54:28 12/16/05 Oh, you are talking pinion preload. That's an entirely.. - Audioquest 11:01:03 12/16/05 Re: Oh, you are talking pinion preload. That's an entirely.. - thumper300zx 11:07:55 12/16/05 Basically the shaft coming out the front has... - Audioquest 11:51:20 12/16/05 Neat ;) (n/m) - thumper300zx 12:49:36 12/16/05 It takes quit a bit of torque on that nut to crush the - Spddracer 22:03:41 12/16/05 ...o.k., and again, if that's all it is, I'm fine with it. (n/m) - thumper300zx 10:03:01 12/17/05 Check your BACKLASH. - Drk93TT 10:30:54 12/17/05
Post a Followup	You cannot reply to this message because you are not logged in.