Subject	You have no business w. a boost controller on a stock ECU (n/m)
Posted by	YugoBernie (NoVA) on December 28, 2004 at 12:15 AM
	This message has been viewed 433 times.
In Reply To	Recomended settings for Profec-B Spec-II? posted by zboost on December 27, 2004 at 10:26 PM
Message
Follow Ups	Recomended settings for Profec-B Spec-II? - zboost 22:26:20 12/27/04 Be careful! - NATHAN91'TT 23:46:26 12/27/04 You have no business w. a boost controller on a stock ECU (n/m) - YugoBernie (NoVA) 00:15:48 12/28/04 ProfecB Spec2 is a great controller but there are some - Ash's Z 00:16:39 12/28/04 VTF! (n/m) - PIRANHA(Go Steelers!!!) 00:49:57 12/28/04 2nd ! (n/m) - Luke@tirerack 09:33:59 12/28/04 3rd.... (n/m) - 90NA2TT 10:01:04 12/28/04 great post! - maglito 00:53:19 12/28/04 Thank you very much! (n/m) - zboost 07:56:53 12/28/04 You still have no business w. a BC on a stock ECU (n/m) - YugoBernie (NoVA) 08:40:21 12/28/04 Ecu is going in soon. - zboost 08:48:29 12/28/04 You have no business w. a BC before a ECU. - YugoBernie (NoVA) 09:20:53 12/28/04 "gain set" should be 3 psi lower per Greddy. (n/m) - Woody75 (Denver) 08:25:10 12/28/04 Yeah, start at 3 and you can trim that down in most cases - Ash's Z 10:47:56 12/28/04 My unit tells me 14.4 lbs. and my a/m boost gauge says 16? (n/m) - Pushin'twins 08:30:18 12/28/04 Almost 800 views? wow (n/m) - zboost 08:48:56 12/28/04 Doh! Hadn't disconnected stock solenoids... 9 psi now :) (n/m) - zboost 11:03:37 12/28/04 disconnecting them puts them in safety boost mode FYI - Red October 14:09:27 12/28/04 Leave it off until you get a chip. I hit 19PSI - ShakaShaun 15:57:52 12/28/04
Post a Followup	You cannot reply to this message because you are not logged in.