Subject	Good post - but you can't do the swap! (inside)
Posted by	Tom B (IN) on October 28, 2004 at 2:18 PM
	This message has been viewed 1039 times.
In Reply To	6-speed transmission: gear ratio study posted by Technomancer on October 27, 2004 at 12:56 PM
Message	I posted on this recently. The poster who said it had been done was relying on someone else's word that it had been done. The 350Z's tranny won't fit. I did extensive measurements and comparisons trying to see how it could be made to work, and nothing lines up from the bell housing to the tranny mount to the gearshift. Even the speed sensor's different and doesn't interface with our ECU's. The only part of it that mates with our cars is the input shaft and splines. And if you were thinking about making adapters, good luck to you. Tom Bell IZCC 2802
Follow Ups	6-speed transmission: gear ratio study - Technomancer 12:56:48 10/27/04 Thanks. (n/m) - YugoBernie (NoVA) 13:51:43 10/27/04 Re: 6-speed transmission: gear ratio study - MeterMan 22:28:36 10/27/04 yes. I assume a stock-geared Z has a top speed of 180mph - Technomancer 08:39:46 10/28/04 Good post - but you can't do the swap! (inside) - Tom B (IN) 14:18:46 10/28/04 Gee Tom, did you miss this post? It's been done! - Technomancer 14:37:24 10/28/04
Post a Followup	You cannot reply to this message because you are not logged in.