Subject	definitely. I saved my old ones. Gonna rejuvenate the
Posted by	robo (sebring1970) on September 22, 2004 at 10:47 PM
	This message has been viewed 159 times.
In Reply To	Robo -- either method is non-destructive if I just want to posted by jzack on September 22, 2004 at 10:37 PM
Message	rubber part, then sand, paint, sand, paint, sand, paint . . . then stare at them or sell them, I dunno. Goodspeed sells "trim" paint that I plan on using [ http://www.goodspeedmotoring.com/subcat.php?get_category=2&get_subcategory=Exterior%20Trim%20Paint ]
Follow Ups	updated molding install, includes rear 1/4 panel glass - robo (sebring1970) 21:47:18 09/22/04 You should actually be sliding the molding on and off - ImTheDevil 22:04:09 09/22/04 I tried that, thought my way was easier, and very safe - robo (sebring1970) 22:11:19 09/22/04 Robo -- either method is non-destructive if I just want to - jzack 22:37:38 09/22/04 definitely. I saved my old ones. Gonna rejuvenate the - robo (sebring1970) 22:47:43 09/22/04 OK, thx. (n/m) - jzack 22:49:45 09/22/04 Thanks for the nice write up ROBO!:) (n/m) - Yuichi(KurumaZ.com) 00:19:45 09/23/04 Yur most welcome. excellent product, better than I xpct'd. (n/m) - robo (sebring1970) 00:41:32 09/23/04 I didn't have much luck with your way... - ImTheDevil 00:35:21 09/23/04 That molding is "CHOICE". :) - Spongerider :) 12:04:52 09/23/04 That is info I've wanted/needed for quite a while... - Zdude32 04:02:08 09/25/04
Post a Followup	You cannot reply to this message because you are not logged in.