TwinTurbo.NET: Nissan 300ZX forum - I tried that, thought my way was easier, and very safe
Subject
I tried that, thought my way was easier, and very safe
Posted by
robo (sebring1970)
on September 22, 2004 at 10:11 PM
This message has been viewed
140
times.
In Reply To
You should actually be sliding the molding on and off
posted by ImTheDevil
on September 22, 2004 at 10:04 PM
Message
since the clips and the back of the molding are somewhat pliable. If the feedback is strongly toward sliding them on and off instead of popping, I'll change my article. Thanks for the feedback.
Follow Ups
updated molding install, includes rear 1/4 panel glass
-
robo (sebring1970)
21:47:18 09/22/04
You should actually be sliding the molding on and off
-
ImTheDevil
22:04:09 09/22/04
I tried that, thought my way was easier, and very safe -
robo (sebring1970)
22:11:19 09/22/04
Robo -- either method is non-destructive if I just want to
-
jzack
22:37:38 09/22/04
definitely. I saved my old ones. Gonna rejuvenate the
-
robo (sebring1970)
22:47:43 09/22/04
OK, thx. (n/m)
-
jzack
22:49:45 09/22/04
Thanks for the nice write up ROBO!:) (n/m)
-
Yuichi(KurumaZ.com)
00:19:45 09/23/04
Yur most welcome. excellent product, better than I xpct'd. (n/m)
-
robo (sebring1970)
00:41:32 09/23/04
I didn't have much luck with your way...
-
ImTheDevil
00:35:21 09/23/04
That molding is "CHOICE". :)
-
Spongerider :)
12:04:52 09/23/04
That is info I've wanted/needed for quite a while...
-
Zdude32
04:02:08 09/25/04
Post a
Followup
You cannot reply to this message because you are not
logged in
.