TwinTurbo.NET: Nissan 300ZX forum - You should actually be sliding the molding on and off
Subject
You should actually be sliding the molding on and off
Posted by
ImTheDevil
on September 22, 2004 at 10:04 PM
This message has been viewed
140
times.
In Reply To
updated molding install, includes rear 1/4 panel glass
posted by robo (sebring1970)
on September 22, 2004 at 09:47 PM
Message
open the hatch and push the molding towards the front of the car, then the opposite to put them back on :)
Follow Ups
updated molding install, includes rear 1/4 panel glass
-
robo (sebring1970)
21:47:18 09/22/04
You should actually be sliding the molding on and off -
ImTheDevil
22:04:09 09/22/04
I tried that, thought my way was easier, and very safe
-
robo (sebring1970)
22:11:19 09/22/04
Robo -- either method is non-destructive if I just want to
-
jzack
22:37:38 09/22/04
definitely. I saved my old ones. Gonna rejuvenate the
-
robo (sebring1970)
22:47:43 09/22/04
OK, thx. (n/m)
-
jzack
22:49:45 09/22/04
Thanks for the nice write up ROBO!:) (n/m)
-
Yuichi(KurumaZ.com)
00:19:45 09/23/04
Yur most welcome. excellent product, better than I xpct'd. (n/m)
-
robo (sebring1970)
00:41:32 09/23/04
I didn't have much luck with your way...
-
ImTheDevil
00:35:21 09/23/04
That molding is "CHOICE". :)
-
Spongerider :)
12:04:52 09/23/04
That is info I've wanted/needed for quite a while...
-
Zdude32
04:02:08 09/25/04
Post a
Followup
You cannot reply to this message because you are not
logged in
.