Subject	be careful not to bend them putting them back on
Posted by	dogpile on September 10, 2004 at 7:09 PM
	This message has been viewed 411 times.
In Reply To	Windshield/T-top/roof trim removal writeup (LOTS of pics) posted by my91z on September 10, 2004 at 06:00 PM
Message	do that yet? when i was putting my drivers side back on i had a bitch of a time. id get 2 clips good, then going for the third the middle one would pop out. but it eventually, but the very top of the drivers side needed to be bent back just before i hooked that final clip. could never tell once it was fully on, but it was practically bent at a 45* angle before that. and if soemones that anal bout drilling a hole in that part of the t-top, they can epxoy it (robo) hey, i used to have a z!
Follow Ups	Windshield/T-top/roof trim removal writeup (LOTS of pics) - my91z 18:00:39 09/10/04 nice. (n/m) - Spongerider :) 18:06:23 09/10/04 man, it was really grody underneath your molding - robo (sebring1970) 18:21:31 09/10/04 Yeah, a bunch of nasty crap >> - my91z 18:30:36 09/10/04 yeah, easier, but the "long" way enables replacement - robo (sebring1970) 18:45:32 09/10/04 link to another tech page on molding replacement - robo (sebring1970) 21:17:16 09/10/04 be careful not to bend them putting them back on - dogpile 19:09:23 09/10/04 Hmm, I snapped the DS pretty much all the way back on > - my91z 20:11:44 09/10/04 i probly did - dogpile 14:10:43 09/11/04 its ahhhhnold! nice plasma (n/m) - Solidpantz 09:39:27 09/11/04 Those 3 pics are the ones I "borrowed" from PLEAZURE :-) (n/m) - my91z 09:56:37 09/11/04
Post a Followup	You cannot reply to this message because you are not logged in.