adjusted my clutch after my JWT install. I just went out and backed both these all the way out and when they were flush with the bracket, the tips were just barley in contact with the pad and not holding up the clutch pedal at all. I screwed them in a turn or so just so the tips were just full depressed and locked them in right there. I did not move the rod as it feels perfect where it is and it was almost perfectly where you said it should be anyway. I only had to turn the sensors in enough to bury the tips and stopped right there. I assume this is ok? I must have just gotten lucky on the cluth adj, because I had no idea what I was doing the first time, I just knew it was too close to the floor. I wish I would have tried to remove that vent crap the first time like I did that time!!! It makes a ton more room!! Thanks Greg!!
|