Subject	return line test results>>
Posted by	komplexZTT on May 30, 2024 at 9:24 AM
	This message has been viewed 74 times.
In Reply To	thanks for the input! posted by komplexZTT on May 23, 2024 at 08:41 AM
Message	Idle, No Vac to FPR 44psi, 12psi return Idle, Vac to FPR 35psi, 13psi return Short drive Idle, No Vac to FPR 38psi, 8psi return Idle, Vac to FPR 28psi, 9psi return Sooo, doesn't seem like return is restricted, FPR or pump?... I would think the FPR should hold absolute pressure, no matter pump is 50-100psi, regulator should be to set value(43.5)? Isn't that the point of a regulator ...so FPR bad? I can adjust it and get pressure back up..so not that the pressure isn't available from pump. Thoughts 2+2=4; 2+0=2; 4>2 : 2+2 > 2+0.
Follow Ups	Base Fuel Pressure Issue: Walbro 485 and Tomei FPR - komplexZTT 07:20:31 05/23/24 Lets Talk about the Basics. - Cjw3 08:35:03 05/23/24 thanks for the input! - komplexZTT 08:41:28 05/23/24 visual inspection on hard lines look ok - komplexZTT 17:17:34 05/25/24 return line test results>> - komplexZTT 09:24:40 05/30/24 pressure gauge cause issues? - komplexZTT 08:21:20 05/30/24 Have you looked at the pump yet? - zwzweston 14:55:37 06/08/24 I did replace the strainer - komplexZTT 06:56:06 06/11/24
Post a Followup	You cannot reply to this message because you are not logged in.