Subject	Re: Make sure the ABS sensors/connectors are good
Posted by	BoucheyZ on September 16, 2023 at 1:10 PM
	This message has been viewed 235 times.
In Reply To	Make sure the ABS sensors/connectors are good posted by Polishzx on September 13, 2023 at 01:51 PM
Message	I am going to pull those today, along with the fronts, to clean them. I have read they are magnetic and it would be safe to assume they have accumulated a lot of debris over the years. Would the number of splines make a difference? The fact that the ECU is programmed with the R230 and not the R200? I figured this wouldn't be a problem since the light will only come on if I drive more than 5mph. Unless the sensors are programmed to read the spline input at that speed? I finally got it back today from the body shop so I will hopefully figure it out.
Follow Ups	ABS Light After NA to TT Conversion - BoucheyZ 01:27:02 09/13/23 Make sure the ABS sensors/connectors are good - Polishzx 13:51:19 09/13/23 Re: Make sure the ABS sensors/connectors are good - BoucheyZ 13:10:04 09/16/23
Post a Followup	You cannot reply to this message because you are not logged in.