Subject	How did you set the shims?
Posted by	BlackholeZ on April 14, 2023 at 6:18 PM
	This message has been viewed 134 times.
In Reply To	Re: I'm also in the same predicament posted by cc on April 07, 2023 at 07:35 PM
Message	I had mine done by a reputable local motorsports shop but I feel like they've got the bearings too tight. I have to pry the diff out after I unbolt the shackles and have to wedge in the last shim with a brass hammer. It's REALLY tight and seems like it gets hotter than it should on a basic drive. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Differential howling - rebuild options? - tommyp98 13:35:56 04/07/23 I'm also in the same predicament - shawmanz32na 16:29:02 04/07/23 Re: I'm also in the same predicament - cc 19:35:21 04/07/23 How did you set the shims? - BlackholeZ 18:18:07 04/14/23 Cost of used NA diffs is pretty low - simpler to replace. (n/m) - Bernie (NoVA) 00:14:04 04/09/23 Ideas on where to start looking for a low mileage used one? (n/m) - tommyp98 20:33:46 04/11/23 What types of shops are you asking? - Zxpress 11:14:03 04/09/23 Been asking transmission shops but will expand to 4x4s (n/m) - tommyp98 20:32:55 04/11/23
Post a Followup	You cannot reply to this message because you are not logged in.