Subject	Ok. Found the problem. But don't understand what happened
Posted by	Zxpress on March 10, 2023 at 12:34 PM
	This message has been viewed 259 times.
Message	Pulled the CAS and discovered the end(pin) broke off. When I reinstalled it, I could tell it was hanging up and kept tweaking it until it all but seated. At least I think I did. I've only read that misaligning the keys will cause it to break if you try to tighten it. What the hell? Maybe from the enormous amount of banging and it sort of cocking in the mount taper caused it to crack? It was really stuck in there. Don't wanna break another one.
Follow Ups	Ok. Found the problem. But don't understand what happened - Zxpress 12:34:08 03/10/23 Re: Ok. Found the problem. But don't understand what happened - itsa300zx 17:33:28 03/11/23 No crank was due to..... - Zxpress 15:02:41 03/17/23 The CAS aligment mechanics are fairly robust to the point - LitlElvis 13:04:55 03/12/23 Good advice. I'll follow up for the next poor guy.... - Zxpress 15:03:46 03/17/23 The JWT claim is real for early 90 motors. - Bernie (NoVA) 21:59:41 03/23/23
Post a Followup	You cannot reply to this message because you are not logged in.