Subject	Re: All the Same
Posted by	itsa300zx on February 28, 2023 at 10:12 AM
	This message has been viewed 150 times.
In Reply To	All the Same posted by Cjw3 on February 28, 2023 at 08:48 AM
Message	I use a simple IC extractor to remove the eprom, not all sockets are made the same. Most are just a rectangular ring with no backing in the center. (unlike the one shown in Cjw3 write up) Be careful not to damage the tracing under to eprom/socket if using a screw driver to pry it up. Very important to have the eprom "half moon indent" lined up to the board marking.
Follow Ups	Chip Replacement - z-u-later 07:02:59 02/28/23 All the Same - Cjw3 08:48:31 02/28/23 Re: All the Same - itsa300zx 10:12:14 02/28/23 Re: Re: All the Same - z-u-later 11:51:07 02/28/23
Post a Followup	You cannot reply to this message because you are not logged in.