Subject	Just reviewed the Factory Table
Posted by	Cjw3 on January 03, 2023 at 1:05 PM
	This message has been viewed 149 times.
In Reply To	Its a Start Table that goes from -40C to +110C posted by Cjw3 on January 03, 2023 at 11:43 AM
Message	It looks like I cut my Table more than Half in the lower Temps, with Half Reduction in the Higher Temps.. I did not realize I had messed with the Hot Start as well as the Cold Start.. Cj
Follow Ups	Hot Start Issue that is resolved by unplugging the CTS - matt34533 15:21:46 01/02/23 Re: Hot Start Issue that is resolved by unplugging the CTS - Cjw3 18:51:44 01/02/23 Re: Re: Hot Start Issue that is resolved by unplugging the CTS - matt34533 19:10:21 01/02/23 Re: Re: Re: Hot Start Issue that is resolved by unplugging the CTS - Cjw3 19:40:49 01/02/23 Re: Re: Re: Re: Hot Start Issue that is resolved by unplugging the CTS - matt34533 21:19:29 01/02/23 I have a 90 NA that gives me fits as well - Cjw3 06:26:25 01/03/23 Re: I have a 90 NA that gives me fits as well - matt34533 11:05:18 01/03/23 Its a Start Table that goes from -40C to +110C - Cjw3 11:43:08 01/03/23 Just reviewed the Factory Table - Cjw3 13:05:35 01/03/23 Re: Its a Start Table that goes from -40C to +110C - matt34533 13:19:45 01/03/23 Re: Its a Start Table that goes from -40C to +110C - matt34533 17:38:24 01/03/23 Re: Re: Re: Re: Hot Start Issue that is resolved by unplugging the CTS - matt34533 21:25:21 01/02/23 I think it's the expansion of the fuel when hot, which - LitlElvis 12:24:14 01/18/23
Post a Followup	You cannot reply to this message because you are not logged in.