Subject	Re: Re: Re: I think royally fucked up by throwing this in the ultra
Posted by	Kvert on November 19, 2022 at 12:18 PM
	This message has been viewed 255 times.
In Reply To	Re: Re: I think royally fucked up by throwing this in the ultra posted by nonstopna on November 19, 2022 at 11:45 AM
Message	I’d just smooth them out and run it. Dremel with some scotch-brite attachments and it’ll be fine. You have plenty of surface to support cams and oil film. It’s not a piston wall where pits would be bad. Just don’t sonicate your block in Palmolive soap. Lol
Follow Ups	I think royally fucked up by throwing this in the ultra - nonstopna 18:07:33 11/18/22 Are those PITS - Drk93TT 09:14:10 11/19/22 Re: Are those PITS - nonstopna 11:43:32 11/19/22 Re: I think royally fucked up by throwing this in the ultra - Kvert 11:01:00 11/19/22 Re: Re: I think royally fucked up by throwing this in the ultra - nonstopna 11:45:59 11/19/22 Re: Re: Re: I think royally fucked up by throwing this in the ultra - Kvert 12:18:57 11/19/22 Re: Re: Re: Re: I think royally fucked up by throwing this in the ultra - nonstopna 13:29:10 11/19/22 Re: I think royally fucked up by throwing this in the ultra - 666whptt 15:41:01 11/27/22 Re: Re: I think royally fucked up by throwing this in the ultra - 666whptt 16:03:29 11/27/22
Post a Followup	You cannot reply to this message because you are not logged in.