Subject	The flat part of CAS drive pin in the exhaust cam should
Posted by	LitlElvis on November 08, 2022 at 11:54 AM
	This message has been viewed 192 times.
In Reply To	You retimed the cams with adjustable 95+ gears? posted by Z Force1 on November 06, 2022 at 06:44 PM
Message	be inline with the center of the dowel pin, with the D section being on the left side when looking at it from the front of the engine. I'm not recommending anyone to do this, but I have rotated a few of those pins with an 8 point socket that fits over the splines.
Follow Ups	Running lean, hestitation at 3500rpm - Z Force1 20:09:40 11/03/22 Re: Running lean, hestitation at 3500rpm - Cjw3 13:32:27 11/04/22 Some interesting developments today.. - Z Force1 21:27:41 11/05/22 Thank you for the Followup - Cjw3 12:50:28 11/06/22 You retimed the cams with adjustable 95+ gears? - Z Force1 18:44:19 11/06/22 The flat part of CAS drive pin in the exhaust cam should - LitlElvis 11:54:02 11/08/22 Just when you think you own every tool in the world.. - Z Force1 17:26:54 11/12/22 Used for square nuts, I believe it's 5/16" you will need - LitlElvis 12:19:24 11/13/22
Post a Followup	You cannot reply to this message because you are not logged in.