Subject	Cruise Control and Horn Wiring (Replacing Factory Wheel)
Posted by	FRMMatt on September 06, 2022 at 5:00 PM
	This message has been viewed 228 times.
Message	I have removed the aftermarket steering wheel that the previous owner installed and am attempting to replace it with the factory steering wheel. The wires for the cruise control and horn were cut from the clock spring when the aftermarket wheel went in. Wondering if anyone is able to help determine which wires should be soldered where to get both working again. I have determined the yellow wire is horn, but still not where it should be soldered to the clock spring. I appreciate the help!!
Follow Ups	Cruise Control and Horn Wiring (Replacing Factory Wheel) - FRMMatt 17:00:18 09/06/22 Re: Cruise Control and Horn Wiring (Replacing Factory Wheel) - FRMMatt 17:06:24 09/06/22 Solved! - FRMMatt 10:29:55 09/07/22
Post a Followup	You cannot reply to this message because you are not logged in.