Subject	Re: Re: Why are my turbos so slow to spool? (Dyno printout included)
Posted by	fir.333 on September 06, 2022 at 9:11 AM
	This message has been viewed 230 times.
In Reply To	Re: Why are my turbos so slow to spool? (Dyno printout included) posted by Buckaroo Banzai on September 03, 2022 at 12:15 PM
Message	Wastegates were verified at 15psi on both before install (I garage did the install for me but they confirmed this) I had run one but using a terrible handheld tyre inflator. I have since bought a compressor to run a test at higher pressure and I do indeed have a few boost leaks... so this must be the cause. My biggest leaks appear to be from the turbo outlet gaskets. I may upgrade to the steel Z1 gaskets, I assume paper ones are installed currently. Does anyone know if those are good?
Follow Ups	Why are my turbos so slow to spool? (Dyno printout included) - fir.333 04:55:32 09/03/22 Re: Why are my turbos so slow to spool? (Dyno printout included) - fir.333 05:02:28 09/03/22 Re: Why are my turbos so slow to spool? (Dyno printout included) - fir.333 05:04:37 09/03/22 Re: Re: Why are my turbos so slow to spool? (Dyno printout included) - Chucks-feed-and-seed 09:54:02 09/03/22 Re: Why are my turbos so slow to spool? (Dyno printout included) - Buckaroo Banzai 12:15:54 09/03/22 Re: Re: Why are my turbos so slow to spool? (Dyno printout included) - fir.333 09:11:43 09/06/22
Post a Followup	You cannot reply to this message because you are not logged in.