Subject	1995 FSM shows it in section EM on page 40
Posted by	Bernie (NoVA) on September 05, 2022 at 7:43 PM
	This message has been viewed 214 times.
In Reply To	I need a torque spec for the transmission cross member. posted by ChrisZTT(Sacto, CA) on September 05, 2022 at 04:57 PM
Message	38-48 ft/lbs for the 3 on each side But the value for the 2 side studs on the trans mount to cat support bracket is too high, those 2 I max @ 15 lbs. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	I need a torque spec for the transmission cross member. - ChrisZTT(Sacto, CA) 16:57:48 09/05/22 1995 FSM shows it in section EM on page 40 - Bernie (NoVA) 19:43:36 09/05/22 JFC Bernie, that's some Zen-Buddha enlightment sheeaht - robo (sebring1970) 20:52:03 09/05/22 Thanks Bernie! (n/m) - ChrisZTT(Sacto, CA) 21:48:30 09/05/22 Sure. (n/m) - Bernie (NoVA) 00:03:04 09/09/22
Post a Followup	You cannot reply to this message because you are not logged in.