Subject	A few steps in general:
Posted by	MixManMash on May 06, 2022 at 11:10 AM
	This message has been viewed 155 times.
In Reply To	Haltech ATI input to operate a dso posted by MeatMan (604Z) on May 04, 2022 at 11:19 PM
Message	1. You have to setup your I/O: ATI2 to a temperature sensor and setup the calibration/scaling of hte sensor. DSO2 as oil cooler fan relay. 2. Add a new map / table in Haltech and essentially set the temperature at which you want DSO2 to turn on. Should be as simple as that.
Follow Ups	Haltech ATI input to operate a dso - MeatMan (604Z) 23:19:56 05/04/22 A few steps in general: - MixManMash 11:10:18 05/06/22
Post a Followup	You cannot reply to this message because you are not logged in.