Subject	Follow the procedure to verify
Posted by	ZaXxon on February 10, 2022 at 10:42 AM
	This message has been viewed 151 times.
In Reply To	Re: How much offset? Few tooth or way out like >90deg? posted by aztec300z on February 06, 2022 at 05:31 PM
Message	Once you think you have it lined up. Rotate the motor by hand a few revolutions to ensure you don't have any interferences. Once that's done, count teeth and verify belt tension.
Follow Ups	Timming belt - aztec300z 17:37:52 02/05/22 Re: Timming belt - aztec300z 11:17:09 02/06/22 How much offset? Few tooth or way out like >90deg? - itsa300zx 12:44:47 02/06/22 Re: How much offset? Few tooth or way out like >90deg? - aztec300z 17:31:30 02/06/22 Count teeth. - MixManMash 20:25:58 02/07/22 Follow the procedure to verify - ZaXxon 10:42:04 02/10/22 Re: Timming belt - MikeJ 06:29:34 02/15/22 I thought the same thing before I did mine. No matter how - Woodnutz (PA) 10:45:13 02/22/22 Are you doing the full 120k or just some parts and belt? >>> - ZUL8TR 04:46:58 02/18/22 Re: Are you doing the full 120k or just some parts and belt? >>> - MikeJ 13:33:13 03/04/22
Post a Followup	You cannot reply to this message because you are not logged in.