Subject	Not the nuts and bolts.
Posted by	Sleeper_TTZ(SeKy) on January 15, 2022 at 5:10 PM
	This message has been viewed 186 times.
In Reply To	Thank you! posted by TTwinTTurboZ on January 14, 2022 at 04:19 PM
Message	I cut the actual down pipe as close to the turbo as I could to open up the area a little bit. It worked out fairly well. Don't cut the fasteners on the turbo. SRC="http://i217.photobucket.com/albums/cc22/SleeperTT/av- 969.gif">
Follow Ups	Down Pipe Install - TTwinTTurboZ 10:59:02 01/12/22 Cut 1/2" wrenches. (n/m) - MixManMash 16:25:38 01/12/22 2nd (n/m) - Unluky (MO) 08:02:17 01/13/22 Just did it on the new Z - Sleeper_TTZ(SeKy) 19:11:43 01/12/22 Thank you! - TTwinTTurboZ 16:19:59 01/14/22 Don't cut the bolts/stud, unless you plan on replacing them. - itsa300zx 18:16:28 01/14/22 Not the nuts and bolts. - Sleeper_TTZ(SeKy) 17:10:55 01/15/22 Re: Just did it on the new Z - TTwinTTurboZ 16:23:40 01/14/22 And lot's of PB Blaster or Royal Purple Max Film. - MixManMash 17:20:44 01/13/22 Re: And lot's of PB Blaster or Royal Purple Max Film. - TTwinTTurboZ 16:22:32 01/14/22 I used this DP install technique a few years ago... - MikeD (Philly) 19:46:43 01/23/22 Thanks - TTwinTTurboZ 15:16:14 01/27/22 universal angle exts work wonders in these tight spaces (n/m) - MikeD (Philly) 08:45:30 01/28/22
Post a Followup	You cannot reply to this message because you are not logged in.