Subject	Oil pan front seal not long enough?
Posted by	Brainzed on December 14, 2021 at 12:06 PM
	This message has been viewed 246 times.
Message	Hi All, I'm new to the Z32/VG30 platform, and I'm currently trying to replace the oil pan while I have the engine out of the car. I have everything ready to go, but the front half moon seal that goes around the oil pump appear about 1cm too short to meet the flat surface of the block. Is this normal? It's an OEM seal from Z1, and if I compare it to the old seal, they look the same except the old seal appears stretched in this area. Wondering if I should bite the bullet and order a new one just in case or just slather that part of the pan in RTV and install it anyway.
Follow Ups	Oil pan front seal not long enough? - Brainzed 12:06:37 12/14/21 Re: Oil pan front seal not long enough? - itsa300zx 12:41:42 12/14/21 Re: Re: Oil pan front seal not long enough? - Brainzed 13:19:51 12/14/21 Re: Re: Re: Oil pan front seal not long enough? - itsa300zx 14:09:42 12/14/21 Wrong part makes sense. - Brainzed 14:19:34 12/14/21 Wrong or faux parts are out there especially if not bagged. (n/m) - ZUL8TR 04:27:13 12/15/21 Yep, agreed. But we should expect more from Z1. (n/m) - itsa300zx 10:46:31 12/15/21
Post a Followup	You cannot reply to this message because you are not logged in.