Subject	transmission will not go in
Posted by	Unicuma on September 14, 2021 at 11:00 PM
	This message has been viewed 343 times.
Message	Hello all, I am doing a 5 speed swap on my 93. I have it all ready. I have replaced the pilot bearing, clutch, flywheel, pressure plate, throwout bearing and clutch fork. I install the flywheel, clutch and pressure plate with the alignment tool and its fine. But when I go to put the transmission in it wont go all the way in. Its about an inch from being all the way in. The input shaft goes through the clutch teeth then gets stuck a bit after. I have tried 2 OEM pilot bearings, and the NISMO one from Z1. But it still will not go all the way in. Please help ive been stuck for 3 days.
Follow Ups	transmission will not go in - Unicuma 23:00:13 09/14/21 Make sure the alignment tool goes all the way into the pilot - Ted (92TT) 01:16:24 09/15/21 Remove intake pipes and lean the engine back towards - itsa300zx 09:53:03 09/15/21 This for me as well. We fought mine, but I read a tip - Unluky (MO) 08:10:40 09/16/21 Re: transmission will not go in - Metacom 18:51:13 09/15/21 This exact thing happened to me - Mongoose 21:28:23 09/15/21 This. (n/m) - Bernie (NoVA) 22:02:35 09/15/21 Also make sure the battery harness ground isn't trapped - Bernie (NoVA) 22:03:24 09/15/21 LOL, yep this too^^^ - itsa300zx 13:45:52 09/16/21 Agreed. I had this problem too the last time I put my - Inzane 14:49:28 09/21/21 Agreed. Those plastic alignment tools have too much play. - MixManMash 20:11:44 09/19/21
Post a Followup	You cannot reply to this message because you are not logged in.