Subject	still code 34
Posted by	reggeo on August 29, 2021 at 12:05 PM
	This message has been viewed 194 times.
Message	what can cause a code 34 with new knock sensor after rebuild. Connection from ECU to connector is also fine. When cold she runs fine, at operation temperature she starts to hesitate in lower RPMS. At Idle warmed up she's stays at 750RPM no ups or downs. - bypassed EGR solenoid - bypassed AIV solenoid - bypassed PRVR solenoid - carbon canister not deleted yet - Blitz EBC thanks in advance
Follow Ups	still code 34 - reggeo 12:05:07 08/29/21 Re: still code 34 - reggeo 14:10:03 08/30/21 Make sure you haven't mixed up the connector between a VTC - MixManMash 19:05:25 08/30/21 I have no idea what you are talking about - nudge, nudge, - slvrblt 23:41:33 08/30/21 Haha. My pleasure Jim. (n/m) - MixManMash 07:43:10 09/04/21 Re: Make sure you haven't mixed up the connector between a VTC - reggeo 10:53:26 09/07/21 Re: Make sure you haven't mixed up the connector between a VTC - reggeo 10:57:45 09/07/21 Code 34 Identical connectors. - CmyZ 09:54:17 08/31/21 Re: Code 34 Identical connectors. - reggeo 10:58:16 09/07/21 What was the issue? ECU connector wasn't seated properly? (n/m) - itsa300zx 10:49:54 09/09/21 Re: What was the issue? ECU connector wasn't seated properly? - reggeo 08:24:20 09/11/21 Re: What was the issue? ECU connector wasn't seated properly? - reggeo 08:26:06 09/11/21
Post a Followup	You cannot reply to this message because you are not logged in.