Subject	Re: Yes, that screw should turn easily so long as it's the right
Posted by	Gagej on August 13, 2021 at 11:39 AM
	This message has been viewed 186 times.
In Reply To	Yes, that screw should turn easily so long as it's the right posted by FrozTTy on August 13, 2021 at 08:09 AM
Message	Made sure to get the platinum NGK. Car was already using those as well so that’s a plus. Now for the adjustment screw I watched a couple of videos to double check I was in the right spot. I’m confident I was but even after warming the car up and disconnecting the harness the screw wouldn’t budge. I don’t know how to attach a picture.. I would just to make sure. I also noticed a vacuum hose was missing from the balance bar. It’s connected at the back side of it closer to the cabin on the driver side. Not sure what is supposed to be there or if good could have any effect…
Follow Ups	Beginner Drift build - Gagej 22:42:47 07/30/21 You got some reading to do - Cjw3 08:08:14 07/31/21 Re: You got some reading to do - Gagej 13:56:42 07/31/21 Engine Out is better - Cjw3 19:25:22 07/31/21 Is it a 2+2? The longer wheelbase will make it a better - MixManMash 17:40:16 08/01/21 Re: Is it a 2+2? The longer wheelbase will make it a better - Gagej 19:43:23 08/01/21 Yes it is. - Cjw3 06:51:44 08/02/21 Engine compartment is the same between coupe and 2+2 - ZXoltan 16:01:09 08/02/21 No, the power switched mod and PRVR delete are two separate - FrozTTy 15:37:58 08/02/21 Rough Idle Help - Gagej 14:50:43 08/02/21 Power Balance Test - FrozTTy 15:27:25 08/02/21 Re: Power Balance Test - Gagej 18:49:16 08/02/21 Update - Gagej 15:42:55 08/04/21 Injector Ohm Test - Gagej 22:48:00 08/04/21 Remove coil pack connector from injector - FrozTTy 11:11:38 08/05/21 Re: Remove coil pack connector from injector - Gagej 18:25:53 08/05/21 Look at all fuel hoses for leaks, that's usually why you'll - FrozTTy 10:41:09 08/06/21 Re: Look at all fuel hoses for leaks, that's usually why you'll - Gagej 21:57:20 08/12/21 Yes, that screw should turn easily so long as it's the right - FrozTTy 08:09:17 08/13/21 Re: Yes, that screw should turn easily so long as it's the right - Gagej 11:39:24 08/13/21 Update - Gagej 16:04:18 08/04/21
Post a Followup	You cannot reply to this message because you are not logged in.