Subject	Beginner Drift build
Posted by	Gagej on July 30, 2021 at 10:42 PM
	This message has been viewed 271 times.
Message	Hello everyone, I recently bought a 1993 NA 300zx. It came with an auto transmission and 135k miles. My plans for the car are to make a beginner drift build. As of now I’m not too worried about making more power, I’m sure that’ll come later down the road. My first plan is to do a manual swap, I plan on just buying the Z1 motor sports full conversion kit and doing it myself to gain the experience. After that I want to install a hydraulic e brake, upgrade the brakes and add coil overs/ freshen up suspension. I’d like to add a couple of strut bars as well. I’d appreciate any input on any of my plans and relevant personal experience. Finally the car has a rough idle, I’m thinking maybe a dirty EGR, but I would appreciate the advice or any other explanations.
Follow Ups	Beginner Drift build - Gagej 22:42:47 07/30/21 You got some reading to do - Cjw3 08:08:14 07/31/21 Re: You got some reading to do - Gagej 13:56:42 07/31/21 Engine Out is better - Cjw3 19:25:22 07/31/21 Is it a 2+2? The longer wheelbase will make it a better - MixManMash 17:40:16 08/01/21 Re: Is it a 2+2? The longer wheelbase will make it a better - Gagej 19:43:23 08/01/21 Yes it is. - Cjw3 06:51:44 08/02/21 Engine compartment is the same between coupe and 2+2 - ZXoltan 16:01:09 08/02/21 No, the power switched mod and PRVR delete are two separate - FrozTTy 15:37:58 08/02/21 Rough Idle Help - Gagej 14:50:43 08/02/21 Power Balance Test - FrozTTy 15:27:25 08/02/21 Re: Power Balance Test - Gagej 18:49:16 08/02/21 Update - Gagej 15:42:55 08/04/21 Injector Ohm Test - Gagej 22:48:00 08/04/21 Remove coil pack connector from injector - FrozTTy 11:11:38 08/05/21 Re: Remove coil pack connector from injector - Gagej 18:25:53 08/05/21 Look at all fuel hoses for leaks, that's usually why you'll - FrozTTy 10:41:09 08/06/21 Re: Look at all fuel hoses for leaks, that's usually why you'll - Gagej 21:57:20 08/12/21 Yes, that screw should turn easily so long as it's the right - FrozTTy 08:09:17 08/13/21 Re: Yes, that screw should turn easily so long as it's the right - Gagej 11:39:24 08/13/21 Update - Gagej 16:04:18 08/04/21
Post a Followup	You cannot reply to this message because you are not logged in.