TwinTurbo.NET: Nissan 300ZX forum - Hmmmm, didn't even know they were NLA. That sucks.
Subject
Hmmmm, didn't even know they were NLA. That sucks.
Posted by
itsa300zx
on June 09, 2021 at 11:49 AM
This message has been viewed
191
times.
In Reply To
RPS Flywheel Segment wear…
posted by Z-line
on June 08, 2021 at 12:06 AM
Message
If I remember correctly they were about 0.015-0.020" above the pressure plate mounting holes, new. If it was less than half that, I'd scrap it. I guess if they are not heat damaged should be ok.
Follow Ups
RPS Flywheel Segment wear…
-
Z-line
00:06:02 06/08/21
Hmmmm, didn't even know they were NLA. That sucks. -
itsa300zx
11:49:16 06/09/21
E-mailed Seb and he said they’re planning on
-
Z-line
22:12:36 06/09/21
Broke the outer ring gear welds from the flywheel
-
ShakaShaun(Denver)
17:32:57 06/14/21
Post a
Followup
You cannot reply to this message because you are not
logged in
.