Subject	Shown here but don’t pull in out just loosen it
Posted by	itsa300zx on May 23, 2021 at 11:27 PM
	This message has been viewed 167 times.
In Reply To	No, it’s hidden behind the ps pump pulley. posted by itsa300zx on May 23, 2021 at 11:22 PM
Message	[ http://www.twinturbo.net/nissan/300zx/forums/technical/view/1164698/There-is-no-nut-on-the-back-of-the-pivot-bolt-to-fall-out.html ]
Follow Ups	Power steering bracket tensioner issues - MNZTTR 13:41:01 05/23/21 Good chance you’ll need to use a pry bar to persuade - Woodnutz (PA) 17:53:32 05/23/21 Did you loosen the pivot bolt? Need to align one of the hole - itsa300zx 18:07:12 05/23/21 Re: Did you loosen the pivot bolt? Need to align one of the hole - MNZTTR 18:36:52 05/23/21 No, it’s hidden behind the ps pump pulley. - itsa300zx 23:22:13 05/23/21 Shown here but don’t pull in out just loosen it - itsa300zx 23:27:18 05/23/21 Re: Shown here but don’t pull in out just loosen it - MNZTTR 08:51:53 05/24/21 This is where a pry bar or large flathead helps. Leverage - Woodnutz (PA) 08:50:53 05/26/21
Post a Followup	You cannot reply to this message because you are not logged in.