Subject	Good chance you’ll need to use a pry bar to persuade
Posted by	Woodnutz (PA) on May 23, 2021 at 5:53 PM
	This message has been viewed 160 times.
In Reply To	Power steering bracket tensioner issues posted by MNZTTR on May 23, 2021 at 01:41 PM
Message	it over. With old, fairly thick hydraulic hoses connected to the pump, it’s not going to just walk back on it’s own... that said, be sure to back off the adjusting bolt a good bit beforehand. You could try squeezing the belt together, but that method didn’t help me too much. I just did my pulleys about a month ago. - Aaron
Follow Ups	Power steering bracket tensioner issues - MNZTTR 13:41:01 05/23/21 Good chance you’ll need to use a pry bar to persuade - Woodnutz (PA) 17:53:32 05/23/21 Did you loosen the pivot bolt? Need to align one of the hole - itsa300zx 18:07:12 05/23/21 Re: Did you loosen the pivot bolt? Need to align one of the hole - MNZTTR 18:36:52 05/23/21 No, it’s hidden behind the ps pump pulley. - itsa300zx 23:22:13 05/23/21 Shown here but don’t pull in out just loosen it - itsa300zx 23:27:18 05/23/21 Re: Shown here but don’t pull in out just loosen it - MNZTTR 08:51:53 05/24/21 This is where a pry bar or large flathead helps. Leverage - Woodnutz (PA) 08:50:53 05/26/21
Post a Followup	You cannot reply to this message because you are not logged in.