Subject	Re: CEL light flashing is it reporting a fault code.
Posted by	R3spawnn on May 10, 2021 at 3:57 PM
	This message has been viewed 173 times.
In Reply To	CEL light flashing is it reporting a fault code. (n/m) posted by Bernie (NoVA) on May 10, 2021 at 12:39 PM
Message	Cel stays solid when I start up. When I run data scan the only code I’m getting is 14. There are times when I start and the AT check light goes solid for 2 seconds then blinks 16 equal times.
Follow Ups	Code 14....... - R3spawnn 18:48:59 05/06/21 Re: Code 14....... - R3spawnn 18:57:26 05/06/21 Re: Code 14....... - R3spawnn 19:28:13 05/06/21 Even tho the speedo is working, that could be where the - Polishzx 20:43:39 05/06/21 Re: Even tho the speedo is working, that could be where the - R3spawnn 21:19:51 05/06/21 Re: Re: Even tho the speedo is working, that could be where the - R3spawnn 21:37:58 05/06/21 Re: Re: Re: Even tho the speedo is working, that could be where the - itsa300zx 22:02:30 05/06/21 Re: Re: Re: Re: Even tho the speedo is working, that could be where the - R3spawnn 22:18:14 05/06/21 Clusters need to match - if it was not from a automatic - Bernie (NoVA) 12:38:22 05/10/21 Re: Re: Re: Re: Even tho the speedo is working, that could be where the - R3spawnn 10:11:28 05/08/21 See if techno@comcast.net still works - Zxpress 11:07:33 05/08/21 Re: See if techno@comcast.net still works - R3spawnn 16:24:19 05/08/21 Re: Re: See if techno@comcast.net still works - Zxpress 17:28:27 05/08/21 Re: Re: Even tho the speedo is working, that could be where the - R3spawnn 21:51:03 05/06/21 CEL light flashing is it reporting a fault code. (n/m) - Bernie (NoVA) 12:39:29 05/10/21 Re: CEL light flashing is it reporting a fault code. - R3spawnn 15:57:58 05/10/21 Does the "new" cluster have an "auto" light between the - Bernie (NoVA) 12:40:23 05/10/21 Re: Does the "new" cluster have an "auto" light between the - R3spawnn 15:55:06 05/10/21 The grease is in those connectors on purpose. Don't clean it (n/m) - Bernie (NoVA) 12:35:50 05/10/21
Post a Followup	You cannot reply to this message because you are not logged in.