Subject	Thanks for the advice.
Posted by	ZXoltan on May 05, 2021 at 2:10 PM
	This message has been viewed 185 times.
In Reply To	I've used a stack of feeler gauges and a Crescent wrench posted by LitlElvis on May 05, 2021 at 11:00 AM
Message	Sounds like they should be fairly easy to remove. I recall trying a few years ago with a chisel that was about the right width(used it like a screwdriver and even tried pliers on the blade for more torque), but couldn't get the valves to budge. Thanks for confirmation that I was turning in the correct direction!
Follow Ups	Best method to remove VTC valve at rear of cam? - ZXoltan 16:19:55 05/03/21 Grind down a wider screwdriver to fit, straight blade sides (n/m) - Doug71zt(CAN) 20:34:53 05/03/21 Thanks. Will I need an impact driver or anything? - ZXoltan 21:10:53 05/03/21 I've used a stack of feeler gauges and a Crescent wrench - LitlElvis 11:00:07 05/05/21 Thanks for the advice. - ZXoltan 14:10:10 05/05/21 FWIW- Problem solved - ZXoltan 14:43:04 05/17/21
Post a Followup	You cannot reply to this message because you are not logged in.