Subject	Re: Running in oil - 10/30 or 10/40?
Posted by	Cjw3 on May 02, 2021 at 12:02 PM
	This message has been viewed 202 times.
In Reply To	Running in oil - 10/30 or 10/40? posted by DanielThomas on May 02, 2021 at 09:02 AM
Message	I was taught to use a thinner oil, so it can 'Flush' through the bearings and get the debris out.. and you want to make sure the oil can get into any 'Unexpected' tight spots, so they can still get lubed and hopefully Burnish off any irregularities of the surfaces.. then the debris gets flushed out Cj
Follow Ups	Running in oil - 10/30 or 10/40? - DanielThomas 09:02:00 05/02/21 Re: Running in oil - 10/30 or 10/40? - Cjw3 12:02:17 05/02/21 Re: Re: Running in oil - 10/30 or 10/40? - DanielThomas 12:38:16 05/02/21 Re: Re: Re: Running in oil - 10/30 or 10/40? - Cjw3 17:47:50 05/02/21 In all honesty, I have done the following on several new - MixManMash 15:48:50 05/02/21 I used Royal Purple break-in oil (10W-30) with good results (n/m) - ZaXxon 09:18:47 05/03/21
Post a Followup	You cannot reply to this message because you are not logged in.