Subject	Hmm thats a weird one.
Posted by	Drk93TT on May 01, 2021 at 6:12 AM
	This message has been viewed 233 times.
In Reply To	Someone please help..before I torch this car :) posted by Stanky (BC) on April 30, 2021 at 05:01 PM
Message	Maybe Bernie has seen before? Cas connector/ wiring, PTU would be the obvious top suspects. Weird it still runs the same seems like when pulling spark at 1,3,5. Also check the 2 main bolted grounds on back of plenum clean and tight. The guy above with the intake cam thing sounds like a weird possibility too, pop the oil cap off and see if she spinnin.
Follow Ups	Someone please help..before I torch this car :) - Stanky (BC) 17:01:52 04/30/21 andddd a new pump/ confirmed fuel pressure good... (n/m) - Stanky (BC) 17:05:25 04/30/21 My car developed a misfire a few years ago. - JMartz 17:17:20 04/30/21 This one seems pretty unlikely, but for S&G's, Pat, you can - Woodnutz (PA) 20:50:07 04/30/21 Ditto - megaDan 21:05:29 04/30/21 Although not very likely, you should check the - timz 18:42:04 04/30/21 He would have bypassed his fuel pump controller. - MixManMash 20:37:38 04/30/21 Check the injector sub harness to main harness connection - MixManMash 21:21:53 04/30/21 Also check that the ECU connector is seated properly and - MixManMash 21:23:24 04/30/21 Thanks for the responses guys - Stanky (BC) 09:45:39 05/01/21 Re: Someone please help..before I torch this car :) - 93TTZ5401 22:00:05 04/30/21 Re: Someone please help..before I torch this car :) - lymon 23:27:20 04/30/21 Never even thought of this, but will check it out .. (n/m) - Stanky (BC) 09:58:07 05/01/21 data logs... anything from the Haltech? - vorpalZed 01:09:14 05/01/21 I will log stuff tomorrow, I also talked with seb - Stanky (BC) 15:19:44 05/01/21 Possible. You might luck out and find a new 95 OEM - MixManMash 17:04:40 05/01/21 What the difference in a 95’ harness compared to a 91? - Stanky (BC) 19:05:46 05/01/21 CAS, injector and AC compressor connectors. - MixManMash 19:22:34 05/01/21 I havent seen any feedback yet on the Z1 EGI harness. - ZXoltan 10:26:33 05/04/21 Hmm thats a weird one. - Drk93TT 06:12:30 05/01/21 So, in addition to my suggestions above, I think it's time - MixManMash 08:24:10 05/01/21 ... or... time for that 2J swap. (n/m) - Woodnutz (PA) 22:04:16 05/01/21 LS is a better answer. (n/m) - MixManMash 23:41:08 05/01/21 Blasphemer (n/m) - Zeus 13:40:06 05/04/21 Appears 1 and 3 not firing. 5 is. Load test ptu switched - mrchips 07:47:18 05/03/21 You should recount your timing belt cogs. ;-) (n/m) - MeatMan (604Z) 13:30:31 05/07/21
Post a Followup	You cannot reply to this message because you are not logged in.