Subject	That is correct (n/m)
Posted by	ZUL8TR on May 01, 2021 at 3:24 AM
	This message has been viewed 151 times.
In Reply To	Re: Re: Lesson learned, but why didn’t you compare the tap posted by itsa300zx on April 30, 2021 at 06:23 PM
Message
Follow Ups	Rod bolt thread size? - DanielThomas 10:20:52 04/25/21 Re: Rod bolt thread size? - DanielThomas 13:27:56 04/25/21 doubtful it's 3/8-16, more than likely it's 3/8-24 (n/m) - LitlElvis 11:56:11 04/27/21 Re: doubtful it's 3/8-16, more than likely it's 3/8-24 - DanielThomas 16:32:14 04/27/21 Lesson learned, but why didn’t you compare the tap - itsa300zx 19:49:56 04/27/21 Re: Lesson learned, but why didn’t you compare the tap - DanielThomas 18:09:43 04/30/21 Re: Re: Lesson learned, but why didn’t you compare the tap - itsa300zx 18:23:33 04/30/21 That is correct (n/m) - ZUL8TR 03:24:35 05/01/21 When you get the new rod assembly weight it and the old>> - ZUL8TR 03:34:48 05/01/21 Re: When you get the new rod assembly weight it and the old>> - DanielThomas 14:31:50 05/01/21 Please... just take this engine to a competent builder - LitlElvis 12:23:51 05/05/21
Post a Followup	You cannot reply to this message because you are not logged in.