Subject	Re: Lesson learned, but why didn’t you compare the tap
Posted by	DanielThomas on April 30, 2021 at 6:09 PM
	This message has been viewed 173 times.
In Reply To	Lesson learned, but why didn’t you compare the tap posted by itsa300zx on April 27, 2021 at 07:49 PM
Message	My fault for believing what i read on the internet. However, I did check to compare them and the rod and the tap both mesh together. Where I really mucked up is using an electric wrench to put the bolt in, in the first place. I had put the oil pickup on already and was accessing the bolt at an angle which caused the cross-threading. Definitely a rookie mistake that I wont do again. Screwing them in by hand next time! I've got the rod ordered, now I just have to work out how to balance the new one.. The cap on it had material removed to balance it and for some reason the chap on the live chat at eagle seems to think I can't swap the caps over? Time to learn.
Follow Ups	Rod bolt thread size? - DanielThomas 10:20:52 04/25/21 Re: Rod bolt thread size? - DanielThomas 13:27:56 04/25/21 doubtful it's 3/8-16, more than likely it's 3/8-24 (n/m) - LitlElvis 11:56:11 04/27/21 Re: doubtful it's 3/8-16, more than likely it's 3/8-24 - DanielThomas 16:32:14 04/27/21 Lesson learned, but why didn’t you compare the tap - itsa300zx 19:49:56 04/27/21 Re: Lesson learned, but why didn’t you compare the tap - DanielThomas 18:09:43 04/30/21 Re: Re: Lesson learned, but why didn’t you compare the tap - itsa300zx 18:23:33 04/30/21 That is correct (n/m) - ZUL8TR 03:24:35 05/01/21 When you get the new rod assembly weight it and the old>> - ZUL8TR 03:34:48 05/01/21 Re: When you get the new rod assembly weight it and the old>> - DanielThomas 14:31:50 05/01/21 Please... just take this engine to a competent builder - LitlElvis 12:23:51 05/05/21
Post a Followup	You cannot reply to this message because you are not logged in.