Subject	So when the machinist resurfaces my used FW to get >>
Posted by	ZUL8TR on March 21, 2021 at 6:00 AM
	This message has been viewed 167 times.
In Reply To	The FW contact surface with the clutch disc is machined posted by itsa300zx on March 20, 2021 at 02:57 PM
Message	it flat he would then machine the FW outside the disk OD to be 0.008" lower. ZUL8TR
Follow Ups	NA flywheel resurface what are particulars to tell>>>>>> - ZUL8TR 04:25:21 03/18/21 Re: NA flywheel resurface what are particulars to tell>>>>>> - Kvert 12:57:35 03/18/21 I have a NA not a TT so looking for street drive clutch kit (n/m) - ZUL8TR 13:45:11 03/18/21 JWT Street Clutch for the NA is a good choice. (n/m) - MixManMash 20:04:10 03/18/21 Facts (n/m) - Bernie (NoVA) 15:57:26 03/19/21 Re: NA flywheel resurface what are particulars to tell>>>>>> - itsa300zx 13:07:28 03/18/21 My go to for street NA is JWT, I prefer to step the FW .008 (n/m) - Bernie (NoVA) 15:57:05 03/19/21 Not familiar with stepping FW 0.008. Does the NA FW have > - ZUL8TR 05:39:01 03/20/21 The FW contact surface with the clutch disc is machined - itsa300zx 14:57:28 03/20/21 So when the machinist resurfaces my used FW to get >> - ZUL8TR 06:00:01 03/21/21 Correct (n/m) - itsa300zx 10:50:18 03/21/21
Post a Followup	You cannot reply to this message because you are not logged in.