Subject	The FW contact surface with the clutch disc is machined
Posted by	itsa300zx on March 20, 2021 at 2:57 PM
	This message has been viewed 203 times.
In Reply To	Not familiar with stepping FW 0.008. Does the NA FW have > posted by ZUL8TR on March 20, 2021 at 05:39 AM
Message	0.008" higher than the pressure plate mounting hole surface. In other words center area (dia of the clutch disc OD) is thicker than the outer flywheel. This helps increase clamping force especially as the disc wears over time.
Follow Ups	NA flywheel resurface what are particulars to tell>>>>>> - ZUL8TR 04:25:21 03/18/21 Re: NA flywheel resurface what are particulars to tell>>>>>> - Kvert 12:57:35 03/18/21 I have a NA not a TT so looking for street drive clutch kit (n/m) - ZUL8TR 13:45:11 03/18/21 JWT Street Clutch for the NA is a good choice. (n/m) - MixManMash 20:04:10 03/18/21 Facts (n/m) - Bernie (NoVA) 15:57:26 03/19/21 Re: NA flywheel resurface what are particulars to tell>>>>>> - itsa300zx 13:07:28 03/18/21 My go to for street NA is JWT, I prefer to step the FW .008 (n/m) - Bernie (NoVA) 15:57:05 03/19/21 Not familiar with stepping FW 0.008. Does the NA FW have > - ZUL8TR 05:39:01 03/20/21 The FW contact surface with the clutch disc is machined - itsa300zx 14:57:28 03/20/21 So when the machinist resurfaces my used FW to get >> - ZUL8TR 06:00:01 03/21/21 Correct (n/m) - itsa300zx 10:50:18 03/21/21
Post a Followup	You cannot reply to this message because you are not logged in.