Subject	Could be so many things.
Posted by	MixManMash on February 25, 2021 at 5:48 PM
	This message has been viewed 209 times.
In Reply To	What would cause a rebuilt motor to eat the rod bearings? posted by DanielThomas on February 25, 2021 at 04:52 PM
Message	Maybe the clearances weren't perfect. Maybe there were oiling issues (internally in the crank / block). What did you use for oil? I typically just use a conventional 10W30 on a new engine when breaking it in and once broken in swap to a good synthetic.
Follow Ups	What would cause a rebuilt motor to eat the rod bearings? - DanielThomas 16:52:06 02/25/21 Could be so many things. - MixManMash 17:48:18 02/25/21 Re: Could be so many things. - DanielThomas 18:14:20 02/25/21 Re: Re: Could be so many things. - Cjw3 18:57:13 02/25/21 Re: Re: Re: Could be so many things. - DanielThomas 19:19:44 02/25/21 Did it see higher RPM with the Gibbs oil? - Doug71zt(CAN) 20:13:57 02/25/21 Re: Did it see higher RPM with the Gibbs oil? - DanielThomas 10:39:20 02/26/21 Did you find a reason why the LH clyinders were not sealing? (n/m) - LitlElvis 16:48:19 03/06/21
Post a Followup	You cannot reply to this message because you are not logged in.