Subject	Re: Bell housing bolt size for engine stand
Posted by	Rob260 on December 02, 2020 at 4:59 AM
	This message has been viewed 200 times.
In Reply To	Bell housing bolt size for engine stand posted by Tdadz32tt on December 01, 2020 at 01:42 PM
Message	Measure the fingers on the stand and add 15mm. One (USDM passenger side at the bottom) will need to pass through the bell ousting and secure with a nut so take that jnto account.
Follow Ups	Bell housing bolt size for engine stand - Tdadz32tt 13:42:21 12/01/20 Thread size is M10x1.5mm, depending on your stand... - itsa300zx 14:39:01 12/01/20 Just checked, 75mm is enough for my stand. (n/m) - itsa300zx 19:25:02 12/01/20 Re: Bell housing bolt size for engine stand - Rob260 04:59:38 12/02/20
Post a Followup	You cannot reply to this message because you are not logged in.