Subject	Suggestions for tightening oil feed lines on turbos
Posted by	EnchantedZ on September 24, 2020 at 9:20 AM
	This message has been viewed 192 times.
Message	Got my rebuilt 90TT engine in and running, so now I'm cleaning up all the other gremlins I can find. Have two small oil leaks coming from the top of each turbo and I've narrowed it down to the flange fitting on the oil feed line. Maybe a full drip or two a minute. Must not have gotten them seated all the way on install. I've removed AIVs, EGR, and PRVR, but the driver side I still have no idea how to get a line or crows foot wrench down in there. Anybody have suggestions on how to get to the nut on the feed line without... pulling the engine again :( 1990 TT w/ the Engine Delete Mod... currently rebuilding, check back Spring 2020!
Follow Ups	Suggestions for tightening oil feed lines on turbos - EnchantedZ 09:20:22 09/24/20 Re: Suggestions for tightening oil feed lines on turbos - homerandabe69 08:11:35 10/06/20
Post a Followup	You cannot reply to this message because you are not logged in.