Subject	Re: Care to explain what I'm looking at and how the test is
Posted by	itsa300zx on August 17, 2020 at 10:27 PM
	This message has been viewed 192 times.
In Reply To	Care to explain what I'm looking at and how the test is posted by Tanley (ATL) on August 17, 2020 at 05:42 PM
Message	The test is simulating boost condition. Pressurize the larger port and the 6mm nipple together. This should hold pressure. Disconnect the 6mm nipple and pressurize the large port only, this should recirculate through the smaller port. ie off throttle.
Follow Ups	Driver side recirc. valve leaking. - Tanley (ATL) 09:11:45 08/16/20 The BDE GHK will not fix any leaks unless the vac port - itsa300zx 15:22:20 08/16/20 Here is a vid on how to bench test recirc valves. - itsa300zx 22:26:18 08/16/20 Care to explain what I'm looking at and how the test is - Tanley (ATL) 17:42:47 08/17/20 Re: Care to explain what I'm looking at and how the test is - itsa300zx 22:27:29 08/17/20 Where is the smoke coming from? If from the small hole in - LitlElvis 11:17:54 08/18/20 Hard to tell. I need to get the front fascia off to get a - Tanley (ATL) 14:00:52 08/18/20
Post a Followup	You cannot reply to this message because you are not logged in.