Subject	Re: Are you doing any machine work to the block?
Posted by	DanielThomas on August 09, 2020 at 12:35 PM
	This message has been viewed 145 times.
In Reply To	Are you doing any machine work to the block? posted by Doug71zt(CAN) on August 07, 2020 at 03:58 PM
Message	So far just ported the water passages, i may get them to shave a bit off the block just to make sure its totally flat. If the machine shop remove the valves and jets, do i simply buy more and they press fit back in?
Follow Ups	How to change block oil galley & brass plugs? - DanielThomas 10:15:13 08/06/20 Re: How to change block oil galley & brass plugs? - DanielThomas 10:40:01 08/06/20 I drill them, tap them and screw a bolt in to slide-hammer - Doug71zt(CAN) 09:12:53 08/07/20 Don't forget the check valves and jets at the deck surface. (n/m) - Doug71zt(CAN) 09:14:14 08/07/20 Re: How to change block oil galley & brass plugs? - DanielThomas 11:32:15 08/07/20 Are you doing any machine work to the block? - Doug71zt(CAN) 15:58:20 08/07/20 Re: Are you doing any machine work to the block? - DanielThomas 12:35:59 08/09/20 Re: Are you doing any machine work to the block? - DanielThomas 14:48:50 08/09/20 Yes, just knock new ones in with a punch. - Doug71zt(CAN) 11:23:48 08/10/20 Part Numbers - Doug71zt(CAN) 11:28:49 08/10/20
Post a Followup	You cannot reply to this message because you are not logged in.